CDOCS a SPEAR Company

CEREC Chairside 4.2.4 Service Pack Now Available


SERVICE PACK CEREC SW 4.2.4

Update Description

The service pack CEREC SW 4.2.4 updates existing CEREC SW 4.2.0, 4.2.1, and 4.2.3 installations. The service pack contains the following changes:

  • Fixed "cut forever" effect while using cut tool
  • Fixed endless calculations of the restoration proposal
  • Fix that a setup was not possible on an CEREC AC with Omnicam with heater controller directly after booting
  • Fixed Omnicam scanning performance is slowed down by plug-ins
  • Factory setting for spacer changed to 120μm (does not apply for updating existing systems)

An existing CEREC SW 4.2 installation is required for this service pack.
It is recommended all CEREC SW 4.2 users to install this service pack.