Discussion Boards

B. Keith Blankenship Post a New Topic

Created	Title	Replies	Views	Last Reply ↓
08/13 2015	Crowns milling 6-8 mm high w TiBase By: B. Keith Blankenship 3 Replies	3	76	August 14th, 2015 By: Carrie Polster
05/06 2015	Cannot correct the open margin issue By: B. Keith Blankenship 11 Replies	11	260	May 13th, 2015 By: Mark Fleming, D.D.S.
11/19 2014	EMAX crowns not being smooth after glazing By: B. Keith Blankenship 9 Replies	9	268	December 10th, 2014 By: Clive Dickinson
10/31 2012	Help with Emax crown glazing By: B. Keith Blankenship 4 Replies	4	130	October 31st, 2012 By: Charles Lo Giudice
08/09 2012	Wounded Warriors and Cerec... Need some videos! By: B. Keith Blankenship	0	46	August 9th, 2012 By: B. Keith Blankenship
11/16 2011	Ivoclar Oven Changes for everyone! By: B. Keith Blankenship 4 Replies	4	11	November 17th, 2011 By: Michael Saso
11/06 2011	Requirements for 4.0 upgrade for red cam? By: B. Keith Blankenship 1 Reply	1	9	November 6th, 2011 By: Rich Rosenblatt, D.M.D.
10/31 2011	Ideas for Video Section By: B. Keith Blankenship 4 Replies	4	3	October 31st, 2011 By: B. Keith Blankenship
10/26 2011	Fabricating restrations using a PVS IMPRESION By: B. Keith Blankenship 1 Reply	1	0	October 26th, 2011 By: Charles Lo Giudice
10/03 2011	Parameters and Info By: B. Keith Blankenship 3 Replies	3	1	October 6th, 2011 By: Bianca Malin

CEREC 5.3 Software Training Videos - Watch Now!