Discussion Boards

Jaroslaw Kokolus Post a New Topic

Created	Title	Replies	Views	Last Reply ↓
10/29 2019	Advice on healing abutment when using Straumann BLT impants and Vairobas C for abutment By: Jaroslaw Kokolus 2 Replies	2	44	October 30th, 2019 By: Jeffrey Collura
05/22 2019	Can't mill ZirCAD LT IPS e.max ZirCAD LT By: Jaroslaw Kokolus 5 Replies	5	48	May 23rd, 2019 By: Jaroslaw Kokolus
11/18 2018	Three Tooth Quadrant By: Jaroslaw Kokolus 4 Replies	4	102	November 18th, 2018 By: Rich Rosenblatt, D.M.D.
10/16 2017	Glazing problem, getting pitting in glaze after firing emax. By: Jaroslaw Kokolus 10 Replies	10	143	October 18th, 2017 By: Charles Lo Giudice
09/22 2017	Can I change global crown parameters in 4.4 software? By: Jaroslaw Kokolus 5 Replies	5	65	September 22nd, 2017 By: Jaroslaw Kokolus
08/24 2017	proposal way off By: Jaroslaw Kokolus 8 Replies	8	118	August 25th, 2017 By: Jaroslaw Kokolus
08/22 2017	My restorations always seem to be very mobile on prep. By: Jaroslaw Kokolus 8 Replies	8	225	August 22nd, 2017 By: Grady Twohig
06/08 2017	Can't mill emax abutment block after 4.4 software upgrade By: Jaroslaw Kokolus 3 Replies	3	77	June 8th, 2017 By: Mark Stockwell

CEREC 5.3 Software Training Videos - Watch Now!