Firing CEREC e.max 3 Unit Bridges

Bob Conte

10 years ago

Since the release of Ivoclar’s e.max-CAD B32 bridge block, there have been a lot of questions regarding the processing of the ceramic after milling. 

1. Clean appropriately with alcohol/soap and water/steam/ultrasonic. 
2. Fill abutments with the pegging material of your choice. In this case Wonderpeg was used.
3. Create a pillow of pegging material directly on the firing tray and seat the bridge on the pillow.
4. Glaze and characterize as desired.
5. Fire on P1 if using the Programat oven.
6. After firing, you will need to simply polish the tissue side of the pontic.